Product description
Centaur chargers
Quality without compromise. Aluminum housing with epoxy powder coating, drip protection against condensation water and stainless steel mounting parts withstand the toughest demands such as heat, moisture and salty atmospheres.
The circuit boards are reliably protected against corrosion by an acrylic coating.
Temperature sensors ensure that all power components operate within specified limits and, if necessary, the output current is automatically reduced under extreme conditions.
Universal 90 to 265 V input. All models operate in a voltage range from 90 V to 265 V at both 50 Hz and 60 Hz and in a DC voltage range from 90 V to 400 V without any special settings.
Three outputs, each with full output current for simultaneous charging of three battery packs. Each output supplies the full current.
Three-stage charging characteristic with temperature compensation. Centaur initially charges with constant current (bulk) until the charging current has dropped to 70 % of the nominal value.
This is followed by a fixed four-hour constant voltage phase at the end of which a trickle charge phase follows.
The charging voltage is regulated via the internal temperature sensor. (-2 mV / °C per cell).
A dip switch can be used to set the optimum charging voltage values for the respective battery types (e.g. wet battery, gel battery or AGM battery).
Quality without compromise. Aluminum housing with epoxy powder coating, drip protection against condensation water and stainless steel mounting parts withstand the toughest demands such as heat, moisture and salty atmospheres.
The circuit boards are reliably protected against corrosion by an acrylic coating.
Temperature sensors ensure that all power components operate within specified limits and, if necessary, the output current is automatically reduced under extreme conditions.
Universal 90 to 265 V input. All models operate in a voltage range from 90 V to 265 V at both 50 Hz and 60 Hz and in a DC voltage range from 90 V to 400 V without any special settings.
Three outputs, each with full output current for simultaneous charging of three battery packs. Each output supplies the full current.
Three-stage charging characteristic with temperature compensation. Centaur initially charges with constant current (bulk) until the charging current has dropped to 70 % of the nominal value.
This is followed by a fixed four-hour constant voltage phase at the end of which a trickle charge phase follows.
The charging voltage is regulated via the internal temperature sensor. (-2 mV / °C per cell).
A dip switch can be used to set the optimum charging voltage values for the respective battery types (e.g. wet battery, gel battery or AGM battery).
Last viewed:
A product slider follows - use the tab key to navigate to the individual articles.
VICTRON - Centaur Charger 12 Vol
